Table of Contents
Advertisement
5 Performance Data / Operation
Table 5-2
, Fortsetzung
Characteristic
S
Number of PG connections
S
Number of OP connections
Repercussions of the number of SEND/RECV
connections in SPEED SEND/RECV mode
5.3
SEND/RECEIVE interface
5.3.1
Characteristic data
The SEND/RECEIVE interface provides access to communication over TCP,
ISO-on-TCP, ISO transport, and UDP connections.
The following characteristics are important:
Table 5-3
Characteristic data of the SEND/RECEIVE interface
Characteristic
Number of SEND/RECEIVE connections
Number of SEND/RECV connections in
SPEED SEND/RECV mode
Maximum data length for AG_SEND and
AG_RECV functions (FCs)
B−24
Explanation / values
Note the following with SPEED SEND/RECEIVE:
Using SSEND/SRECV reduces the possible
configuration limits of S7 communication with each
configured SEND/RECV connection in SPEED
SEND/RECV mode.
Explanation / values
S
TCP connections: 1...64
S
ISO-on-TCP connections 1 to 64
S
ISO transport connections 1...64
S
UDP connections (specified and free) configurable in total
1 to 64 (of those, up to 48 multicast mode)
S
Max. number of connections in total:
(ISO transport + ISO-on-TCP + TCP + UDP) <= 64
Refer to the example in Section 5.1
1)
Note:
The flow control on TCP connections cannot control
permanent overload of the receiver. You should therefore
make sure that the processing capabilities of a receiving CP
are not permanently exceeded by the sender (approximately
150-200 messages per second).
The number depends on the CPU type being used.
S
Per CPU 412/414 maximum 30
S
Per CPU 416/417 maximum 62
AG_SEND and AG_RECV were shipped with predecessors of
the CP and allow the transfer of data fields with a length from
1 to 240 bytes. The version of the CP described here
continues to support these blocks.
CP 443-1 for Industrial Ethernet / Manual Part B
2 max.
30 max.
1)
Release 07/2010
C79000-G8976-C223−06
Advertisement
Table of Contents
