Syntax
Call the command without parameters:
show dcp server
Result
The overview of the status of the DCP function and access rights is displayed.
6.1.1.4
show ip route
Description
This command shows the routes currently being used.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip route[{<ip-address>[<mask>]|connected|static}]
The parameters have the following meaning:
Parameter
ip-address
mask
connected
static
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The routing table is displayed.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
or
cli#
Description
Shows the information for a specific IP address.
Defines an address range using the subnet mask.
Shows the direct connections.
Shows the static connections.
Network protocols
6.1 IPv4 protocol
Range of values
Specify a valid IP
address
/8, /16 or /24
-
-
173