Chapter 4: Connection Mode - Siemens ADSL 50 User Manual

SANTIS ADSL 50/500 User Manual

Chapter 4: Connection Mode

The ADSL Router is delivered pre-configured from the factory in Router Mode. This chapter presents some
deployment examples for your reference. Each mode includes its general configure procedures. For more detailed
information about web configuration, refer to "Web Configuration".
Router Mode
Bridge Mode
MER Mode
PPPoA+ NAT Mode
PPPoE + NAT Mode
Multiple PVCs Mode
For making sure that you can connect the ADSL to your computer well and get into Internet successfully, please
make sure the following first.
1. Make sure you have installed a network interface card onto your computer.
2. Make sure the connection between the ADSL and your computer is OK.
3. Check to see the TCP/IP protocol and set the IP address as "Auto Get IP Address" (See chapter 3:
When you are sure all above is Ok, you can open the Browser and type in "192.168.1.1" and start to do the web
configuration with different connection modes.
This chapter is going to introduce the function of each connection mode and tell you the basic configuring steps that
you have to do. If you did not follow the configuring steps for using these connection modes, you might get some
connection problems and cannot connect to Internet well.
58