No Switchport Pvid; Commands In The Vlan Configuration Mode - Siemens SCALANCE S615 Configuration Manual

Network structures
5.1 VLAN
5.1.3.8

no switchport pvid

Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport pvid
Result
The setting is reset to the default value.
Further notes
You configure the setting with the
You configure the VLAN ID with the
You can display the status of this function and other information with the
config
5.1.4

Commands in the VLAN configuration mode

This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
When doing this, you need to replace the
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
Configuration mode.
● If you exit the VLAN Configuration mode with the
Privileged EXEC mode.
162
command.
command.
switchport pvid
switchport access vlan
command to change to this mode.
vlan $$$
placeholders with the relevant VLAN ID.
$$$
exit
command, you return to the
end
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
show vlan port
command, you return to the Global
SCALANCE S615 Command Line Interface