Network structures
5.1 VLAN
5.1.4.6
no ports
Description
With this command, you reset the ports for a VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ports
(
)
[
]
[
]
[name<vlan-name>]
The parameters have the following meaning:
Parameter
interface-type
/a-b,0/c,...
untagged
all
forbidden
name
vlan-name
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
168
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
untagged<interface-type> <0/a-b,0/c,...>
(
[<interface-type><0/a-b,0/c,...>]
)
(
forbidden<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>]
)
Description
Type or speed of the interface
Port no. of the interface
Keyword for interfaces or ports that transfer
data packets without VLAN marking
Specifies that all interfaces or ports are set
to "untagged"
Keyword for forbidden interfaces or ports
Keyword for the name assignment
Name of the VLAN
[all]
[all]
[all]
Values
Enter a valid interface.
-
-
-
-
max. 32 characters
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02