Table of Contents
Advertisement
Chapter 3
This chapter describes how to define router configuration settings using the Easy Setup Wizard. These
settings control access to the Wide Area Network (WAN) and Local Area Network (LAN). During the Easy
Setup procedure, you will be prompted to specify configuration parameters that may require information from
your service provider.
Access Easy Setup Wizard
To access the Easy Setup Wizard, click Easy Setup in the left navigation pane of the Router Information
window. This wizard will walk you through the configuration screens necessary to setup the router. You can
exit the Easy Setup Wizard at anytime by clicking Cancel on the bottom of the configuration page. If the wizard
is cancelled, no changes will be made and you will need to begin again.
Select Protocol
When you click Easy Setup in the left navigation
pane of the Router Information page, the WAN
Interface page is displayed. This page is used to
enter and review information about Wide Area
Network (WAN) settings.
To configure the WAN interface:
1. In Data PVC, enter the ATM Permanent Virtual
Circuit (PVC) information: VPI / VCI.
2. From the Wan Protocol list, select the protocol
to use for the WAN connection.
3. Click Next to continue. This displays the page
required to configure the selected protocol. In
the list below, click on the protocol you
selected to jump to the appropriate page.
•
Point-to-Point Protocol over ATM (VC
Multiplexing)
•
Point-to-Point Protocol over ATM (LLC
Encapsulation)
•
Point-to-Point Protocol over Ethernet over PPPoA
•
Point-to-Point Protocol over Ethernet over RFC1483
•
RFC 1483 (Multiprotocol Encapsulation LLC/SNAP)
•
RFC 1483 (VC Multiplexing Routed)
•
RFC 1483 MAC Encapsulated Routing (MER)
•
RAWIP
SIEMENS
Easy Setup
17
Advertisement
Table of Contents
