Source Nat - Siemens SIMATIC NET SCALANCE S615 Configuration Manual

Configuring with Web Based Management
4.8 "Layer 3" menu
● Translated Destination IP
Enter the IP address of the node to which this frame will be forwarded.
● Translated Destination Port
Enter the number of the port. This is the new destination port to which the incoming frame
will be forwarded. If the setting is intended to apply to a port range, enter the range with start
port "-" end port, for example 30 - 40.
The table has the following columns:
● Select
Select the check box in the row to be deleted.
● Source Interface
Shows the interface from which the packets need to come. Only these packets are
considered for port forwarding.
● Traffic Type
Shows the protocol for which the address assignment applies.
● Interface IP
Shows whether the IP address of the interface is used.
● Destination IP
Shows the destination IP address. The frames are received at this IP address.
● Destination Port
Shows the destination port. Incoming frames with this port as the destination port are
forwarded.
● Translated Destination IP
Shows the IP address of the node to which the packets will be forwarded.
● Translated Destination Port
Shows the destination port to which the packets are translated.
4.8.3.3

Source NAT

On this page, you configure the rules for source NAT.
238
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08