No Ntp Server - Siemens SCALANCE S615 Configuration Manual

System time
4.2 NTP client
Requirement
You are in the NTP Configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Syntax
Call up the command with the following parameters:
ntp server{ipv4<ip_addr>}[port<123,1025-36564>][poll<seconds(64-1024)>]
The parameter has the following meaning:
Parameter
ipv4
ip_addr
port
poll
seconds
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The connection to a server is configured on the NTP client.
Further notes
You delete the connection to a server with the
4.2.3.2

no ntp server

Description
With this command, you delete the connection to a server on the NTP client.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
128
Description
Keyword for an IPv4 address
Value for the IPv4 address of the time server
UDP port of the time server
Keyword for the time after which the time of day is re-
quested again
Value for the time in seconds
Range of values / note
-
Enter a valid IPv4 address
123
•
1025 ... 36564
•
Default: 123
-
64 ... 1024
command.
no ntp server
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02