No Src-Nat - Siemens SCALANCE S615 Configuration Manual

Parameter
dstip
ip_addr
ip_range
subnet
transip
ip_addr
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The source NAT rule is created. During creation, an entry with a unique number (index) is
created.
Further notes
You delete a source NAT rule with the
You delete all source NAT rules with the
You display the numbers of the source NAT rules with the
You display the source NAT rule with the
8.1.3.12

no src-nat

Description
With this command, you delete a specific source NAT rule.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Keyword for the destination IP address.
IPv4 address
IPv4 address range
IPv4 address for the subnet
Keyword for the IPv4 address with which the
IPv4 address of the source is replaced.
If the interface has an IPv4 address, the pa-
rameter is optional. In this case, the IPv4 ad-
dress of the interface is used.
no src-nat
no src-nat all
show firewallnat src-nat
Range of values / note
-
Enter a valid IPv4 address.
Specify a valid IPv4 address
range.
Specify the subnet in CIDR
notation.
-
Enter a valid IPv4 address.
command.
command.
src-nat show-idx
command.
Layer 3 functions
8.1 NAT
command.
299