3.4.3
Commands in the SRS configuration mode
This section describes commands that you can call up in the SRS configuration mode.
In the Global configuration mode, enter the
● If you exit the SRS configuration mode with the
configuration mode.
● If you exit the SRS configuration mode with the
EXEC mode.
3.4.3.1
interval
Note
This command is only available with a KEY-PLUG.
Description
With this command, you configure the time after which the IPv4 address will be transferred to
the required destination server.
Requirement
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Syntax
Call up the command with the following parameters:
interval <time (60-86400)>
The parameter has the following meaning:
Parameter
time
Result
The interval is configured.
Further notes
You display this setting and other information with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
srs
Description
Interval in seconds
Functions specific to SCALANCE
command to change to this mode.
command, you return to the Global
exit
command, you return to the Privileged
end
Range of values / note
60 ... 86400
show srs overview
3.4 SRS
command.
99