Interface Range - Siemens SCALANCE S615 Configuration Manual

Network structures
5.1 VLAN
5.1.2.2

interface range

Description
With this command, you can put several interfaces or the interfaces of VLANs together and
configure them together. The configurations are valid for all interfaces of the specified range.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
interface range
(
{<interface-type> <0/a-b,0/c,...>}
{vlan <vlan-id(1-4094)> - <vlan-id(2-4094)>}
)
The parameters have the following meaning:
Parameter
interface-type
0/a-b, 0/c,...
vlan
vlan-id
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you want to address several VLANs with this command, you must insert a blank before
and after the hyphen, for example
Result
The interfaces or interfaces of VLANs were put together to form an interface range.
The command prompt is as follows:
cli(config-if-vlan-range)#
The configuration commands you enter in a mode apply to all interfaces of this area.
Further notes
With the
146
Description
Keyword for an interface
Module no. and port no. of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Number of the addressed VLAN
command, you remove VLANs from this range or break it up.
no interface range
interface range vlan 5 - 10
Configuration Manual, 06/2015, C79000-G8976-C406-02
Range of values / note
Enter a valid interface.
-
1 ... 4094
2 ... 4094
.
SCALANCE S615 Command Line Interface