No Connection Name - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.3 IPsec VPN
Result
You are now in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(config-conn-X)#
Further notes
You exit the IPSEC CONNECTION configuration mode with the
You delete a VPN connection with the
You delete all VPN connections with the
9.3.3.2

no connection name

Description
With this command, you delete a specific VPN connection.
Requirement
● The corresponding VPN connection has been created and is not being used anywhere.
● You are in the IPSEC CONNECTION configuration mode.
Syntax
Call up the command with the following parameters:
no connection name <name(122)>
The parameter has the following meaning:
Parameter
name
Result
The corresponding VPN connection is deleted.
Further notes
You display the VPN connection with the
360
The command prompt is as follows:
cli(config-ipsec-conn-X)#
Description
Name of the VPN connection
command.
no connection name
command.
no connection all
Range of values / note
Enter the name of the VPN con-
nection.
command.
connection name
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
or command.
end exit