6.4.2.1
ip dhcp-server
Description
With this command, you enable the DHCP server on the device.
Note
To avoid conflicts with IPv4 addresses, only one device may be configured as a DHCP
server in the network.
Note
Maximum number of IP addresses
The maximum number of IPv4 addresses that the DHCP server supports is 100. In other
words, a total of 100 IPv4 addresses (dynamic + static).
With the static assignments, you can create a maximum of 20 entries.
Requirement
● NAT is enabled in Client mode
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server
Result
The DHCP server is enabled.
Further notes
You disable the DHCP server with the
6.4.2.2
no ip dhcp-server
Description
With this command, you disable the DHCP server on the device.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
no ip dhcp-server.
Network protocols
6.4 DHCP server
193