Option Value-Hex - Siemens SCALANCE S615 Configuration Manual

Syntax
Call up the command with the following parameters:
no option <option-code>
The parameter has the following meaning:
Parameter
option-code
Result
The specified DHCP option is deleted.
Further notes
You configure the DHCP option 67 with the
You configure the DHCP options 3, 6 and 66 with the
You configure all other DHCP options with the
6.4.3.5

option value-hex

Description
With this command, you create DHCP options that contain a hexadecimal value as DHCP
parameter. The various DHCP options are defined in RFC 2132.
The exceptions are the DHCP options: 1, 3, 66 and 67. You configure the DHCP options 3, 6
and 66 with the command
option value-string
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
option <option-code> value-hex <dhcp-param>
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Code of the DHCP option
(IP address) and the DHCP option 67 with the command
option
.
Range of values / note
Enter a valid number.
command.
option value-string
command.
option
command.
option value-hex
Network protocols
6.4 DHCP server
201