Syntax
Call up the command with the following parameters:
no ip dhcp-server pool <pool-id (1-5)>
The parameter has the following meaning:
Parameter
pool-id
Result
The required IPv4 address band is deleted.
Further notes
You create the IPv4 address band with the
6.4.3
Commands in the DHCPPOOL configuration mode
This section describes commands that you can call up in the DHCPPOOL Configuration
mode.
In the Global Configuration mode, enter the
mode.
● If you exit the DHCPPOOL Configuration mode with the
Global Configuration mode.
● If you exit the DHCPPOOL Configuration mode with the
Privileged EXEC mode.
6.4.3.1
lease-time
Description
With this command, you specify how long the assigned IPv4 address remains valid. Once
this period has elapsed, the device must either request a new IPv4 address or extend the
lease time of the existing IPv4 address.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
ID of the addressed IPv4 address band
Range of values / note
1 ... 5
command.
ip dhcp-server pool
command to change to this
ip dhcp-server pool
command, you return to the
exit
command, you return to the
end
Network protocols
6.4 DHCP server
197