Dhcp Server; Show Commands; Show Ip Dhcp-Server Bindings - Siemens SCALANCE S615 Configuration Manual

6.4

DHCP server

This section describes commands relevant for configuring the DHCP server.
Requirement
The connected devices are configured so that they obtain the IPv4 address from a DHCP
server.
6.4.1

show commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
6.4.1.1

show ip dhcp-server bindings

Description
This command shows the current assignments of IPv4 addresses of the DHCP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ip dhcp-server bindings
Result
The information is displayed.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
do [command]
[command]
or
cli#
you can execute the "show" commands in every
with the "show" command that you want to execute.
Network protocols
6.4 DHCP server
191