Ip Dhcp Client Mode - Siemens SCALANCE S615 Configuration Manual

Network protocols
6.3 DHCP client
Syntax
Call the command without parameters:
no ip dhcp config-file-request
Result
The DHCP config file request option is disabled.
Further notes
You enable the DHCP config file request option with the
command.
6.3.3.3

ip dhcp client mode

Description
With this command, you configure the type of identifier with which the DHCP client logs on
with its DHCP server.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp client mode {mac|client-id<client-id>|sysname}
The parameters have the following meaning:
Parameter
mac
client-id
client-id
sysname
Result
The registration mode of the DHCP client is configured.
190
Description
The client registers with its MAC address
The client registers with the assigned ID
Name of the assigned ID
The client registers with the assigned system
name
ip dhcp config-file-request
Range of values
-
-
max. 32 characters
-
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02