Network protocols
6.1 IPv4 protocol
6.1.2.4
no ip echo-reply
Description
With this command you stop the network node reacting to ping queries.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip echo-reply
Result
"ICMP echo reply messages" are disabled. The network node does not react to ping queries.
Further notes
You change the setting with the
6.1.2.5
ip route
Description
With this command, you configure a static entry in the IP routing table.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip route <prefix> <mask> <next-hop> [<distance(1-255)>]
178
command.
ip echo-reply
Configuration Manual, 06/2015, C79000-G8976-C406-02
SCALANCE S615 Command Line Interface