2.4.3.1
auto-save
Description
The CLI can save changes to the configuration automatically.
If you first want to test changes made to the configuration so that you can discard them
afterwards if necessary, you can disable the auto save function.
You are then in the Trial mode.
Changes to the configuration that you have not saved, are indicated by an asterisk in front of
the command prompt:
You save the changes to the configuration with the
With the
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
auto-save
As default the function is "enabled".
Result
The auto save function is enabled.
Further notes
You save changes to the configuration in the Trial mode with the
command.
You disable the function with the
You can display the status of this function and other information with the
information
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
*cli(...)#
command, you enable the auto save function.
auto-save
command.
.
write startup-config
command.
no auto-save
Configuration
2.4 Configuration Save & Restore
command.
write startup-config
show device
85