Cellular Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
C I
ELLULAR NTERFACE
To create a cellular interface and activate the Cellular Interface Configuration mode, enter the interface
cellular command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface cellular 1/1
(config-cellular 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order:
apn <name> on page 1538
cdma activate oma-dm on page 1539
cdma activate otasp on page 1540
cdma msl <number> on page 1541
custom-profile ha-shared-secret on page 1542
custom-profile home-address <ip address> on page 1543
custom-profile primary-ha-address <ip address> on page 1544
custom-profile secondary-ha-address <ip address> on page 1545
custom-profile username <username> on page 1546
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1547
match ani <template> substitute <template> on page 1548
reset on page 1550
resource pool-member <name> on page 1551
retry-throttling on page 1552
snmp trap cellular on page 1553
snmp trap threshold-ecio <value> on page 1554
snmp trap threshold-rssi <value> on page 1555
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Cellular Interface Command Set

1537