ADTRAN AOS Version R10.1.0 Command Reference Manual page 1504

Command Reference Guide
ip access-class <ipv4 acl name> in
Use the ip access-class in command to restrict Internet Protocol version 4 (IPv4) telnet access using a
configured access control list (ACL). Received IPv4 packets passed by the ACL will be allowed. Use the
ACL configuration to deny hosts or entire networks or to permit specified IPv4 addresses. Use the no form
of this command to disable this feature. Refer to
ip access-list extended <ipv4 acl name> on page 982
Variations of this command include:
ip access-class <ipv4 acl name> in
ip access-class <ipv4 acl name> in any-vrf
Syntax Description
<ipv4 acl name>
any-vrf
Default Values
By default, there are no configured IPv4 ACLs associated with telnet sessions.
Command History
Release 11.1
Release 16.1
Release 18.2
Release R10.1.0
Functional Notes
When using the ip access-class in command to associate an ACL with a telnet session, remember to
duplicate the ip access-class in command for all configured telnet sessions 0 through 4. Telnet access to
the unit using a specific telnet session is not possible. Users will be assigned the first available Telnet
session.
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
routers supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance regardless
of whether multi-VRF is configured.
60000CRG0-35E
ip access-list standard <ipv4 acl name> on page 984
Identifies the configured IPv4 ACL using an alphanumeric descriptor (all
ACL descriptors are case sensitive).
Optional. Allows incoming connections from any VPN routing and
forwarding (VRF) instance based on the parameters set in the access class
list. Without this keyword, the ACL only applies to the default VRF and all
Telnet/SSH connections on nondefault VRFs will be ignored.
Command was introduced.
Command was expanded to include the vrf parameter.
Command was changed to include the ip parameter to accommodate
Internet Protocol version 6 (IPv6) support for ADTRAN internetworking
products only.
Command was changed to include the ip parameter to accommodate
Internet Protocol version 6 (IPv6) support for ADTRAN voice products.
Copyright © 2012 ADTRAN, Inc.
Line (Telnet) Interface Command Set
for more information about configuring ACLs.
and
1504