ADTRAN AOS Version R10.1.0 Command Reference Manual page 1526

Command Reference Guide
caller-id-override
Use the caller-id-override command to configure the unit to replace caller ID information with a
user-specified number. Use the no form of this command to disable any caller ID overrides. Variations of
this command include:
caller-id-override always <number>
caller-id-override if-no-cid <number>
Syntax Description
always <number>
if-no-cid <number>
Default Values
By default, this command is disabled.
Command History
Release 6.1
Functional Notes
This command forces a replacement of the incoming caller ID number with the number given. The received
caller ID, if any, is discarded, and the given override number is used to connect the incoming call to a
circuit of the same number.
Usage Examples
The following example configures the unit to always provide the given number as the caller ID number:
(config)#interface bri 1/2
(config-bri 1/2)#caller-id-override always 5551000
60000CRG0-35E
Always forces replacement of the incoming caller ID number with the
number given.
Replaces the incoming caller ID number with the number given only if there
is no caller ID information available for the incoming call.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
BRI Interface Command Set
1526