ADTRAN AOS Version R10.1.0 Command Reference Manual page 1523

Command Reference Guide
training-mode
Use the training-mode command to configure the asymmetric digital subscriber line (ADSL) training
mode. Use the no form of this command to disable a specific training mode. Variations of this command
include:
training-mode ADSL2
training-mode ADSL2+
training-mode ADSL2+ANNEX-M
training-mode G.DMT
training-mode G.LITE
training-mode Multi-Mode
training-mode Multi-Mode-no-T1413
training-mode READSL2
training-mode T1.413
Syntax Description
ADSL2
ADSL2+
ADSL2+ANNEX-M
G.DMT
G.LITE
Multi-Mode
Multi-Mode-no-T1413
READSL2
T1.413
Default Values
By default, the training mode is set to Multi-Mode.
Command History
Release 8.1
Release 13.1
Release A4.05
Functional Notes
Some of the listed training modes (G.LITE, T1.413, ADSL2, ADSL2+, READSL2) are currently supported
for ADSL over plain old telephone service (POTS) (Annex A) and are not valid for ADSL over integrated
services digital network (ISDN) (Annex B) modules.
60000CRG0-35E
Specifies International Telecommunication Union (ITU) G.992.3 mode.
Specifies ITU G.992.5 mode.
Specifies ITU G.992.5 Annex M mode.
Specifies ANSI full-rate mode.
Specifies ANSI splitterless mode.
Specifies auto detect mode. When set to multi-mode, the ADSL interface
attempts to train to the DSLAM using each of the supported training modes
until a match is found.
Specifies auto detect mode without ANSI T1.413 capability.
Specifies ITU G.992.3 Annex L mode.
Specifies ANSI T1.413 mode.
Command was introduced.
Command was expanded to include the ITU G.992.5 Annex M mode.
Command was expanded to include the Multi-Mode-no-T1413 parameter.
Copyright © 2012 ADTRAN, Inc.
ADSL Interface Command Set
1523