ADTRAN AOS Version R10.1.0 Command Reference Manual page 1529

Command Reference Guide
isdn spid
Use the isdn spid command to specify the service profile identifiers (SPIDs) and the local directory
numbers (LDNs) for the basic rate interface (BRI). This information should be supplied by your service
provider. Use the no form of this command to remove a configured SPID. Variations of this command
include:
isdn spid1 <spid number> <ldn number>
isdn spid2 <spid number> <ldn number>
The BRI module requires all incoming calls to be directed to the LDN associated with the
SPID programmed using the isdn spid1 command. All calls to the LDN associated with
SPID 2 will be rejected (unless part of a bonding call).
Syntax Description
spid1
spid2
<spid number>
<ldn number>
Default Values
By default, there are no configured SPIDs or LDNs.
Command History
Release 1.1
60000CRG0-35E
Specifies the primary SPID.
Specifies the secondary SPID.
Specifies the 8- to 14-digit number identifying your BRI line in the central
office switch. A SPID is generally created using the area code and phone
number associated with the line and a four-digit suffix. For example, the
following SPIDs may be provided on a BRI line with phone numbers
555-1111 and 555-1112:
SPID 1: 701 555 1111 0101
SPID 2: 701 555 1112 0101
Optional. Specifies the LDN assigned to the circuit by the service provider.
An LDN programmed using the isdn spid1 command is automatically
associated with SPID 1. An LDN programmed using the isdn spid2
command is automatically associated with SPID 2. The LDN is the number
used by remote callers to dial into the integrated services digital network
(ISDN) circuit. Inbound calls are not accepted on interfaces without
programmed LDNs. LDNs can also be entered using the isdn ldn
command. The isdn spid and isdn ldn commands overwrite the existing
programmed LDN; therefore, the latest LDN programmed takes
precedence.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
BRI Interface Command Set
1529