Bri Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
BRI I
NTERFACE
To activate the BRI Interface Configuration mode, enter the interface bri command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface bri 1/2
(config-bri 1/2)#
The BRI number in the example above is shown as bri 1/2. This number is based on the
interface's location (slot/port) and could vary depending on the unit's configuration. Use
the do show interfaces command to determine the appropriate interface number.
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
caller-id-override on page 1526
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1527
isdn ldn on page 1528
isdn spid on page 1529
isdn switch-type on page 1531
loopback local on page 1532
loopback network on page 1533
maintenance on page 1534
resource pool-member <name> on page 1535
test-call on page 1536
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

BRI Interface Command Set

1525