Dds Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
DDS I
NTERFACE
To activate the DDS Interface Configuration mode, enter the interface dds command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface dds 1/1
(config-dds 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
clock rate on page 1557
clock source on page 1558
data-coding scrambled on page 1559
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1560
loopback on page 1561
remote-loopback on page 1562
snmp trap on page 1563
snmp trap link-status on page 1564
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

DDS Interface Command Set

1556