SV (shifter overflow) bit, 3-19,
swap register operator, 2-52,
switching from receive to transmit DMA,
10-51
switching from transmit to receive DMA,
10-50
SYSCTL register, 5-12,
System Control (SYSCTL) register,
system design
designing for high frequency operation,
15-15
recommendations and suggestions,
15-16
system registers (SREG),
SZ (shifter zero) bit, 3-19,
T
TAP pin,
6-1
TCB chain loading, 7-10, 7-13,
TCB chain load request,
TCB-to-register loading sequence,
TCK pin, 6-1,
15-12
TCOUNT register,
A-37
TCOUNT (timer count) register,
TDI pin, 6-1,
15-12
TDM method,
9-25
TDO pin,
15-12
technical support,
-xxxiv
termination codes
condition codes and loop termination,
3-19
test, bit,
2-30
test access port (TAP) See JTAG port
test clock See TCK pin
test data input See TDI pin
test data output See TDO pin
test flag (TF) condition, 3-18,
TFSDIV bit,
A-86
three-state vs. three-state,
ADSP-2126x SHARC Processor Hardware Reference
A-14
G-8
A-43
A-43
A-3
A-15
G-10
7-13
7-13
3-46
3-19
G-10
Time-Division-Multiplexed (TDM)
mode, 1-11, 9-1,
G-10
serial system,
9-24
TIMEN (timer enable) bit, 3-46,
timer, 1-8,
3-46
external event watchdog (EXT_CLK)
mode,
14-13
interrupts,
14-5
modes,
14-1
pulsewidth count and capture
(WDTH_CAP) mode,
pulsewidth modulation (PWMOUT)
mode,
14-7
registers,
14-1
timer count (TCOUNT) register,
timer enable (TIMEN) bit,
timer expired high priority (TMZHI),
A-28
timer expired high priority (TMZHI) bit,
3-47
timer expired low priority (TMZLI),
timer expired low priority (TMZLI) bit,
3-47
timer expired See TIMEXP pin
timer input/output (TMRx) pin,
timer period (TPERIOD) register,
timer registers, listed,
A-63
timer word count (TMxCNT) registers,
14-1
TIMERx (bidirectional chip time signal)
pin,
14-1
timer x high word period (T_PRDHx)
registers,
14-1
timer x high word pulse width (T_WHRx)
registers,
14-1
TIMEXP pin,
15-12
TIMOD bit, 10-9,
10-33
TIMOD (transfer initiation mode) bit,
10-43
TMS pin,
15-12
Index
A-9
14-10
3-46
3-46
A-29
14-1
3-46
I-33
Need help?
Do you have a question about the ADSP-21261 SHARC and is the answer not in the manual?
Questions and answers