Enabling Sport Master Mode (Mstr); Selecting Transmit And Receive Channel Order (Frfs); Selecting Frame Sync Options (Difs) - Analog Devices ADSP-21261 SHARC Hardware Reference Manual

SPORT Operation Modes
To transmit or receive words continuously in Left-justified Sample Pair
mode, load the
for 8-bit data words (

Enabling SPORT Master Mode (MSTR)

The SPORTs transmit and receive channels can be configured for Master
or Slave mode. In Master mode, (
word select and serial clock signals for the transmitter or receiver. In Slave
mode, ( = 0) an external source generates the word select and serial
MSTR
clock signals for the transmitter or receiver.
"Setting the Internal Serial Clock and Frame Sync Rates" on page 9-15.

Selecting Transmit and Receive Channel Order (FRFS)

Using the
FRFS
falling) that the SPORTs transmit or receive the first sample. See
Table 9-1 on page 9-10

Selecting Frame Sync Options (DIFS)

When using both SPORT channels (
mitters and
MSTR
frame sync signal only when both transmit buffers contain data because
both transmitters share the same
transmission, both transmit buffers must contain new data.
When using both SPORT channels as transmitters and
= 1 and
SPTRAN
frequency set by
data. The DMA controller or the application is responsible for filling the
transmit buffers with data.
9-16
register with the same value as
FSDIV
= 7), set
SLEN
bit, it is possible to select which frame sync edge (rising or
for more details.
= 1, = 1, and
SPTRAN
CLKDIV
= 1, the processor generates a frame sync signal at the
DIFS
whether or not the transmit buffers contain new
FSDIVx
ADSP-2126x SHARC Processor Hardware Reference
= 7.
FSDIV
= 1) the processor generates the
MSTR
For more information, see
and
SPORTx_DA
= 0, the processor generates a
DIFS
and
SPORTx_FS
. For example,
SLEN
) as trans-
SPORTx_DB
. For continuous
= 1,
MSTR