Table of Contents
Advertisement
Command Reference Guide
DSX-1 Interface Command Set
remote-loopback
Use the remote-loopback command to configure the interface to respond to loopbacks initiated by a
remote unit (or the service provider). Use the no form of this command to disable this feature.
Syntax Description
No subcommands.
Default Values
By default, all interfaces respond to remote loopbacks.
Command History
Release 1.1
Command was introduced.
Usage Examples
The following example enables remote loopbacks on the DSX-1 interface:
(config)#interface t1 1/2
(config-t1 1/2)#remote-loopback
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
1572
Advertisement
Table of Contents
