ADTRAN AOS Version R10.1.0 Command Reference Manual page 1586

Command Reference Guide E1 Interface Command Set
snmp trap line-status
Use the snmp trap line-status command to control the Simple Network Management Protocol (SNMP)
variable dsx1LineStatusChangeTrapEnable (RFC 2495) to enable (or disable) the interface to send SNMP
traps when there is an interface status change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the dsx1LineStatusChangeTrapEnable object identifier (OID) is set to enabled for all interfaces
except virtual Frame Relay interfaces.
Command History
Release 11.1 Command was introduced.
Functional Notes
The snmp trap line-status command is used to control the RFC 2495 dsx1LineStatusChangeTrapEnable
OID (OID number 1.3.6.1.2.1.10.18.6.1.17.0).
Usage Examples
The following example disables the line-status trap on the T1 interface:
(config)#interface e1 1/1
(config-t1 1/1)#no snmp trap line-status
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 1586