ADTRAN AOS Version R10.1.0 Command Reference Manual page 1595

Command Reference Guide
To activate the Ethernet Subinterface Configuration mode, enter the interface ethernet command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface ethernet 0/1.1
(config-eth 0/1.1)#
To activate the Gigabit Switchport Interface Configuration mode, enter the interface gigabit-switchport
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface gigabit-switchport 0/3
(config-giga-swx 0/3)#
To activate the Switchport Interface Configuration mode, enter the interface switchport command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface switchport 0/1
(config-swx 0/1)#
To activate the Ethernet Configuration mode for a range of Ethernet interfaces, enter the interface range
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface range ethernet 0/1, 0/8
(config-eth 0/1, 0/8)#
Not all Ethernet commands apply to all Ethernet types. Use the ? command to display a list
of valid commands. For example:
>enable
Password:xxxxx
#config term
(config)#interface ethernet 0/1
(config-eth 0/1)#?
alias
arp
awcp
bandwidth
etc.
60000CRG0-35E
- A text name assigned by an SNMP NMS
- Set ARP commands
- Enables Adtran Wireless Control Protocol on this interface
- Set bandwidth parameter
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1595