ADTRAN AOS Version R10.1.0 Command Reference Manual page 1585

Command Reference Guide
sa4tx-bit <value>
The sa4tx-bit command selects the Tx value of Sa4 in this E1 interface. Use the no form of this command
to return to the default value.
Syntax Description
<value>
Default Values
The default value for this command is 1.
Command History
Release 6.1
Functional Notes
This command assigns a value to the Tx spare bit in position 4. The odd-numbered frames of TS0 are not
used for frame alignment. Bits in position 4 through 8 are called spare bits. Values of 0 or 1 are accepted.
TS0 odd frame
Bit position 1
Bit use 0
Usage Examples
The following example sets the Tx value of Sa4 to 0:
(config)#interface e1 1/1
(config-e1 1/1)#sa4tx-bit 0
60000CRG0-35E
Specifies a 0 or a 1 for the transmit value of the SA4 bit on the E1.
Command was introduced.
2 3 4 5
1 RAI = 1 S S
Copyright © 2012 ADTRAN, Inc.
6 7 8
S S S
E1 Interface Command Set
1585