Renesas RX100 Series User Manual page 994

RX13T Group
Table 32.11 DC Characteristics (8)
Conditions: VCC = 2.7 V to 5.5 V, AVCC0 = VCC to 5.5 V, VSS = AVSS0 = 0 V, T
The ripple voltage must meet the allowable ripple frequency f
lower limit (2.7 V). When VCC change exceeds VCC ±10%, the allowable voltage change rising/falling gradient dt/dVCC must be
met.
Item
Allowable ripple frequency
Allowable voltage change
rising/falling gradient
VCC
Figure 32.3 Ripple Waveform
Table 32.12 Permissible Output Currents
Conditions: VCC = 2.7 V to 5.5 V, AVCC0 = VCC to 5.5 V, VSS = AVSS0 = 0 V, T
Permissible low-level output
current
Permissible low-level output
current
Permissible high-level output
current
Permissible high-level output
current
Note: Do not exceed the permissible total supply current.
R01UH0822EJ0100 Rev.1.00
Jul 31, 2019
Symbol Min. Typ.
f — —
r (VCC)
— —
— —
dt/dVCC 1.0 —
Item
Large current ports (P71 to P76, PB6)
RIIC pins
Ports other than above
Total of large current ports
Total of all output pins
Large current ports (P71 to P76, PB6)
Ports other than above
Total of large current ports
Total of all output pins
= –40 to +105°C
a
within the range between the VCC upper limit (5.5 V) and
r (VCC)
Max. Unit
10 kHz Figure 32.3
V
r (VCC)
1 MHz Figure 32.3
V
r (VCC)
10 Figure 32.3
V
r (VCC)
— ms/V When VCC change exceeds VCC ±10%
1 / f
r (VCC)
= –40 to +105°C
a
Normal output mode
High-drive output mode
Normal output mode
High-drive output mode
32. Electrical Characteristics
Test Conditions
≤ VCC × 0.2
≤ VCC × 0.08
≤ VCC × 0.06
V
r ( VCC)
Symbol Max.
I 10.0
OL
6.0
4.0
8.0
ΣI 50
OL
110
I –5.0
OH
–4.0
–8.0
ΣI –25
OH
–35
Page 994 of 1041
Unit
mA
mA
mA
mA