Texas Instruments OMAP5912 Reference Manual page 491

Configuration
Table 41. Functional Multiplexing Control 12 Register (FUNC_MUX_CTRL_12)
Bit Name
31:30 RESERVED
29:27 RESERVED
26:24 CONF_J8
23:21 CONF_D3
20:18 CONF_C1
17:15 CONF_E4
14:12 CONF_D2
11:9 CONF_F4
8:6 CONF_E3
5:3 CONF_J7
2:0 RESERVED
Table 42. Pulldown Control 4 Register (PULL_DWN_CTRL_4)
Bit Name
31 CONF_PDEN_Y18
30 CONF_PDEN_W18
29 CONF_PDEN_V17
28 CONF_PDEN_Y19
27 CONF_PDEN_V18
26 CONF_PDEN_L3
25 CONF_PDEN_M8
24 CONF_PDEN_M7
74 Initialization
Base Address = 0xFFFE 1000, Offset Address = 0xA0
Function
Reserved for future expansion.
Reserved for future expansion.
Controls multiplexing on J8. Formerly CONF_FADD_1_R.
Controls multiplexing on D3. Formerly CONF_FADD_2_R.
Controls multiplexing on C1. Formerly CONF_FADD_3_R.
Controls multiplexing on E4. Formerly CONF_FADD_4_R.
Controls multiplexing on D2. Formerly CONF_FADD_5_R.
Controls multiplexing on F4. Formerly CONF_FADD_6_R.
Controls multiplexing on E3. Formerly CONF_FADD_7_R.
Controls multiplexing on J7. Formerly CONF_FADD_8_R.
Reserved for future expansion.
This register controls functional multiplexing. COMP_MODE_CTRL_0 must
be programmed to 0xEAEF for this register to control functional multiplexing.
See Table 8 for bit-field values.
Base Address = 0xFFFE 1000, Offset Address = 0xAC
Function
Enables (0) pullup or pulldown on Y18.
Enables (0) pullup or pulldown on W18.
Enables (0) pullup or pulldown on V17.
Enables (0) pullup or pulldown on Y19.
Enables (0) pullup or pulldown on V18.
Enables (0) pullup or pulldown on L3.
Enables (0) pullup or pulldown on M8.
Enables (0) pullup or pulldown on M7.
R/W Reset
R/W 0X0
R/W 0x0
R/W 0X0
R/W 0X0
R/W 0X0
R/W 0X0
R/W 0X0
R/W 0X0
R/W 0X0
R/W 0X0
R/W 0X0
R/W Reset
R/W 0X0
R/W 0X0
R/W 0X0
R/W 0X0
R/W 0X0
R/W 0x0
R/W 0x0
R/W 0x0
SPRU752B