Texas Instruments OMAP5912 Reference Manual page 455

Configuration
Table 11. Functional Multiplexing Control O Register (FUNC_MUX_CTRL_0)
(Continued)
Bit Name
28 OBS_288_1
27 UWIRE_HIZ_DISABLE
26 GIGA_UART_GATING
25 BT_UART_GATING
24 COM_UART_GATING
23 USB_TRANS_MUX
22 LB_RESET_DISABLE
21 HSAB_RESET_DISABLE
20 LRU_SEL
19 VBUS_CTRL
18 VBUS_MODE
17:16 UWIRE_DCD
15 OS_TYPE
Notes: 1) This function has been removed. Writing a 1 or a 0 to this register is acceptable. However, it is recommended
to write a 0, in case functions are added to this register space in the future.
38 Initialization
Base Address = 0xFFFE 1000, Offset Address = 0x00
Function
Configures observation mode multiplexing on
the camera interface (See Section 2.3).
0: Observation mode is disabled and camera
interface is in functional mode.
1: Enables the observation mode.
Programming sequence:
1) Configure CONF_OBS_MUX_CTRL_R (see
Section 2.3 for details).
2) Enable the observability multiplexing by
programming OBS_288_1 to 1.
See Note 1
See Note 1
See Note 1
See Note 1
See Note 1
See Note 1
See Note 1
This field configures the OMAP traffic controller
arbitration algorithm.
0: LRU priority scheme is used for arbitration.
1: Fixed priority scheme is used for arbitration.
This bit can be changed only when the DSP is
in reset.
See Note 1
See Note 1
See Note 1
Reserved
R/W Reset
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
SPRU752B