Texas Instruments OMAP5912 Reference Manual page 465

Configuration
Table 22. Functional Multiplexing Control A Register (FUNC_MUX_CTRL_A)
(Continued)
Bit Name
26:24 CONF_V10
23:21 CONF_V11
20:18 CONF_W10
17:15 CONF_P13
14:12 CONF_R13
11:9 CONF_V15
8:6 CONF_P14
5:3 CONF_AA17 Controls multiplexing on AA17. Formerly
2:0 CONF_Y15
Table 23. Functional Multiplexing Control B Register (FUNC_MUX_CTRL_B)
Bit Name
31:30 RESERVED
29:27 CONF_V8
26:24 CONF_Y8
23:21 CONF_W8
20:18 CONF_R10
17:15 CONF_V5
14:12 CONF_V9
11:9 CONF_W9
8:6 CONF_AA9
48 Initialization
Base Address = 0xFFFE 1000, Offset Address = 0x2C
Function
Controls multiplexing on V10. Formerly CONF_MMC_DAT1_R.
Controls multiplexing on V11. Formerly CONF_MMC_CLK_R.
Controls multiplexing on W10. Formerly CONF_MMC_DAT2_R.
Controls multiplexing on P13. Formerly CONF_CLK32K_IN_R.
Controls multiplexing on R13. Formerly CONF_CLK32K_OUT_R.
Controls multiplexing on V15. Formerly CONF_MCSI1_DIN_R.
Controls multiplexing on P14. Formerly CONF_MCSI1_BCLK_R.
Controls multiplexing on Y15. Formerly CONF_BCLK_R.
This register controls functional multiplexing. COMP_MODE_CTRL_0 must
be programmed to 0xEAEFh for this register to control functional multiplexing.
See Table 8 for bit field values.
Base Address = 0xFFFE 1000, Offset Address = 0x30
Function
Reserved for future expansion.
Controls multiplexing on V8. Formerly CONF_ARMIO_3_R.
Controls multiplexing on Y8. Formerly CONF_GPIO_8_R.
Controls multiplexing on W8. Formerly CONF_GPIO_9_R.
Controls multiplexing on R10. Formerly
CONF_COM_MCLK_REQ_R.
Controls multiplexing on V5. Formerly
CONF_COM_MCLK_OUT_R.
Controls multiplexing on V9. Formerly CONF_MCSI2_SYNC_R.
Controls multiplexing on W9 Formerly CONF_MCSI2_DOUT_R.
Controls multiplexing on AA9. Formerly CONF_MCSI2_DIN_R.
CONF_MCSI1_SYNC_R.
R/W Reset
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W Reset
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
R/W 0x0
SPRU752B