Texas Instruments OMAP5912 Reference Manual page 454

Table 10. Configuration Registers (Continued)
Name
FUNC_MUX_ARM_DMA_G
MOD_CONF_CTRL_1
CONF_STATUS
RESET_CONTROL
CONF_5912_CTRL
Register descriptions for DMA functional mux registers are in the Multimedia Processor Direct Memory Access (DMA)
Note:
Support Reference Guide (SPRU755).
Table 11. Functional Multiplexing Control O Register (FUNC_MUX_CTRL_0)
Bit Name
31 CTRL_288_1
30 OBS_288_2
29 OBS_600_1
Notes: 1) This function has been removed. Writing a 1 or a 0 to this register is acceptable. However, it is recommended
to write a 0, in case functions are added to this register space in the future.
SPRU752B
Base Address = 0xFFFE 1000
Description
Functional multiplexing MPU DMA G
Module configuration control 1
Configuration status
Reset control register
OMAP5912 configuration control
Base Address = 0xFFFE 1000, Offset Address = 0x00
Function
This bit configures the control mode 288_1,
which enables the control of the OMAP
CHIP_NWAKEUP signal from the RTCK pad.
0: Functional mode. ULPD controls the OMAP
CHIP_NWAKEUP signal.
1: Debug. The RTCK pad controls the OMAP
CHIP_NWAKEUP signal.
See Note 1
See Note 1
Configuration
R/W Offset
R/W 0x104*
R/W 0x110
0x130
R/W 0x140
R/W 0x150
R/W Reset
R/W
R/W
R/W
Initialization
0x0
0x0
0x0
37