Texas Instruments OMAP5912 Reference Manual page 17

1.6 Serial Interfaces
1.7 Camera and Display Interfaces
SPRU748A
OMAP5912 provides several serial interfaces:
-
A master/slave serial port interface (SPI), enabling serial data transfer
compatible with common SPI protocol
-
Three multichannel buffered serial port (McBSP) peripherals, enabling
emulation of the following serial protocols:
J
Serial port interface
J
An I2S-compatible interface
J
A DSP serial input/output
J
Multichannel time division multiplexer
2
-
An I C with multimaster and slave support
-
A multichannel and full duplex serial synchronous interface (SSI)
-
A universal serial bus (USB) interface client, host, and USB On-The-Go
configuration
A serial µWire interface
-
-
Two multichannel serial interfaces (MCSI)
-
Three universal asynchronous transceivers (UART1, UART2, UART3)
-
HDQ and 1-Wire interfaces
There are three video interfaces:
-
The compact camera port (CCP) interface is a unidirectional serial
interface that connects to a camera.
-
The camera IF is an 8-bit parallel interface with horizontal/vertical camera
input signal.
-
Two types of LCD display IFs:
J
An 8-bit/16-bit configurable parallel bidirectional display interface that
enables a smart display connection using the MeSSI standard
J
The OMAP internal LCD controller that enables simple LCD interfaces
and control
Overview
Introduction 17