Texas Instruments OMAP5912 Reference Manual page 153

Table 13. OCP-T1 and OCP-T2 Abort Address Registers—Access Address
(OCPT1_AADDR and OCPT2_AADDR)
Bits Field
31:0 Address
Table 14. OCP-T1 and OCP-T2 Abort Type Registers—Access Address
(OCPT1_ATYPER and OCPT2_ATYPER)
Bits Field
31:5 RESERVED
4 TIMEOUT_ERR
3 BUS_ERR
SPRU749A
The abort time-out register (ATOR) is used to store the number of clock cycles
the OCP target counts down before activating the abort signal because the
peripheral did not return a SRESP signal.
Base Address = 0xFFFE CC00, Offsets = 0xB0 and 0xE4
Description
Address of access that caused abort.
Base Address = 0xFFFE CC00, Offsets = 0xB4 and 0xE8
Description
Reserved. To ensure software compatibility, reserved
bit should be written to 0 and read value should be
considered undefined.
Abort generated by time-out register.
0: No abort
1: Abort
Abort generated by error coming from external
peripherals
0: No abort
1: Abort
Traffic Controller
R/W Reset
R 0x0000 0000
R/W
R/W
R
R
OMAP3.2 Subsystem
Reset
0
0
0
95