Analog Devices SHARC ADSP-214 Series Hardware Reference Manual page 879

Table A-28. SDCTL Register Bit Descriptions (RW)
Bit Name
1–0 SDCL
2 DSDCTL
3 DSDCLK1
7–4 SDTRAS
10–8 SDTRP
11 SDPM
ADSP-214xx SHARC Processor Hardware Reference
www.BDTIC.com/ADI
Description
SDRAM CAS Latency. 2–3 SDCLK cycles. The delay in clock cycles
between when the SDRAM detects the read command and when it
provides the data at its output pins.
00, 01 = Reserved
10 = 2 cycles
11 = 3 cycles
A CAS latency of 2 is supported only up to 133 MHz SDCLK.
Disable Controller and Clocks. Used to enable or disable the SDC. If
DSDCTL is disabled, any access to SDRAM address space does not
occur externally. When DSDCTL is disabled, all SDC control pins
are in their inactive states and the SDRAM clock SDCLK is not run-
ning.
1 = Disable
0 = Activate
When not using SDRAM or when using parts without an external
port, systems should disable this bit as early as possible after booting
to reduce power consumption.
Disable Clock SDCLK1. For ADSP-2148x only.
1 = No effect
0 = Disable SDCLK1
tRAS Specification. Row Active Open Delay is 1–15 SDCLK cycles.
Based on the system clock frequency and the timing specifications of
the SDRAM used. Programmed parameters apply to all four banks in
the external memory. Refer to the SDRAM data sheet.
tRP Specification. Row Precharge Delay is 1–8 SDCLK cycles. Based
on the system clock frequency and the timing specifications of the
SDRAM used. Programmed parameters apply to all four banks in the
external memory. Refer to the SDRAM datas heet.
SDRAM Power-Up Mode. The SDPM and SDPSS bits work
together to specify and trigger an SDRAM power-up (initialization)
sequence. If the SDPM bit is set (=1), the SDC does a precharge all
command, followed by a load mode register command, followed by
eight auto-refresh cycles. If the SDPM bit is cleared (=0), the SDC
does a precharge all command, followed by eight auto-refresh cycles,
followed by a load mode register command.
Refer to the SDRAM data sheet.
Registers Reference
A-53