Ip Rip Send Version - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

ip rip send version

Use the ip rip send version command to configure the Routing Information Protocol (RIP) version the
unit sends in all RIP packets transmitted on the interface. Variations of this command include:
ip rip send version 1
ip rip send version 2
Syntax Description
1
2
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Command History
Release 1.1
Release 5.1
Release A4.01
Functional Notes
Use the ip rip send version command to specify a RIP version that overrides the version (in the Router
RIP) configuration. Refer to
AOS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the Ethernet interface to transmit only RIP version 2 packets:
(config)#interface ethernet 0/1
(config-eth 0/1)#ip rip send version 2
60000CRG0-35E
Transmits only RIP version 1 packets on the interface.
Transmits only RIP version 2 packets on the interface.
Command was introduced.
Command was expanded to include the Ethernet subinterfaces.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet Interface.
version on page 3035 for more information.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1652