Table of Contents
Advertisement
Command Reference Guide
Ethernet Interface Command Set
flowcontrol receive
Use the flowcontrol receive command to enable incoming flow control for the Ethernet interface. If
flowcontrol recieve is enabled, the unit will honor received pause frames. Use the no form of this
command to disable flow control.
Syntax Description
No subcommands.
Default Values
By default, flow control is disabled.
Command History
Release 18.2
Command was introduced.
Usage Examples
The following example specifies that Ethernet interface giga-eth 0/1 honors received pause frames:
(config)#interface gigabit-ethernet 0/1
(config-giga-eth 0/1)#flowcontrol receive
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
1611
Advertisement
Table of Contents
