ADTRAN AOS Version R10.1.0 Command Reference Manual page 1647

Command Reference Guide
ip pim-sparse override-interval <value>
Use the ip pim-sparse override-interval command to specify the protocol-independent multicast (PIM)
sparse join/prune override interval. This delay interval is the period after a join/prune that another router on
the local area network (LAN) may override a join/prune. Use the no form of this command to return to the
default value.
Syntax Description
<value>
Default Values
By default, the override interval is set to 2500 milliseconds.
Command History
Release 11.1
Release A4.01
Usage Examples
The following example sets the override interval to 3000 milliseconds:
(config)#interface ethernet 0/1
(config-eth 0/1)#ip pim-sparse override-interval 3000
60000CRG0-35E
Specifies the delay time in milliseconds. Valid range is 0 to
65535 milliseconds.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet Interface.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1647