ADTRAN AOS Version R10.1.0 Command Reference Manual page 1622

Command Reference Guide
ip dhcp
Use the ip dhcp command to release or renew the Dynamic Host Configuration Protocol (DHCP) Internet
Protocol version 4 (IPv4) address. This command is only applicable when using DHCP for IP address
assignment. Variations of this command include:
ip dhcp release
ip dhcp renew
Syntax Description
release
renew
Default Values
No default values are necessary for this command.
Command History
Release 3.1
Release 8.1
Release A4.01
Release R10.1.0
Usage Examples
The following example releases the IPv4 address assigned (by DHCP) on the Ethernet interface 0/1:
(config)#interface ethernet 0/1
(config-eth 0/1)#ip dhcp release
60000CRG0-35E
Releases the DHCP IPv4 address.
Renews the DHCP IPv4 address.
Command was introduced.
Command was added to the asynchronous transfer mode (ATM)
subinterface.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was added to the bridged virtual interface (BVI).
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1622