ADTRAN AOS Version R10.1.0 Command Reference Manual page 1603

Command Reference Guide
channel-group <number> mode on
Use the channel-group mode on command to statically add the interface to a channel group. To remove
an interface from a channel group, use the no form of this command.
Syntax Description
<number>
Default Values
By default, the interface is not part of a channel group.
Command History
Release 5.1
Functional Notes
There can be up to six channel groups with 2 to 8 interfaces per group. Dynamic protocols are not yet
supported (only static). A physical interface can be a member of only one channel group.
Usage Examples
The following example adds the Ethernet 0/1 interface to channel group 1:
(config)#interface ethernet 0/1
(config-eth 0/1)#channel-group 1 mode on
(config-eth 0/1)#
60000CRG0-35E
Specifies the channel-group number. Range is 1 to 6.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1603