ADTRAN AOS Version R10.1.0 Command Reference Manual page 1742

Command Reference Guide
ip address <ipv4 address> <subnet mask>
Use the ip address command to define an Internet Protocol version 4 (IPv4) address on the specified
interface. Use the no form of this command to remove a configured IPv4 address. Variations of this
command include:
ip address <ipv4 address> <subnet mask>
ip address <ipv4 address> <subnet mask> secondary
Syntax Description
<ipv4 address>
<subnet mask>
secondary
Default Values
By default, there are no assigned IPv4 addresses.
Command History
Release 7.1
Release R10.1.0
Usage Examples
The following example configures an IPv4 address of 192.22.72.101 /30:
(config)#interface fdl 1/1
(config-fdl 1/1)#ip address 192.22.72.101 /30
60000CRG0-35E
Specifies a valid IPv4 address. IPv4 addresses should be expressed in
dotted decimal notation (for example, 10.10.10.1).
Specifies the subnet mask that corresponds to a range of IPv4 addresses
(network) or a specific host. Subnet masks can be expressed in dotted
decimal notation (for example, 255.255.255.0) or as a prefix length (for
example, /24).
Optional. Configures a secondary IPv4 address for the specified interface.
Command was introduced for the facility data link (FDL) interface.
Command was expanded to include the secondary keyword.
Copyright © 2012 ADTRAN, Inc.
FDL Interface Command Set
1742