ADTRAN AOS Version R10.1.0 Command Reference Manual page 1700

Command Reference Guide Ethernet Interface Command Set
In order to prevent the map from being disabled in cases of temporary inadequate bandwidth (e.g., a single
link goes down in a dual T1 multilink configuration where the map requests more than one T1's worth of
bandwidth), the QoS map uses the maximum theoretical bandwidth on an interface, not the actual
bandwidth at that time. This actually helps QoS keep higher priority class-based traffic working better than
best-effort traffic when the bandwidth drops.
Usage Examples
The following example applies the QoS map VOICEMAP to the Ethernet interface:
(config)#interface ethernet 0/1
(config-eth 0/1)#qos-policy out VOICEMAP
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 1700