Switchport Mode - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

switchport mode

Use the switchport mode command to configure the virtual local area network (VLAN) membership
mode. To reset membership mode to the default value, use the no form of this command. The stack
selection does not apply to the NetVanta 300 Series units. Variations of this command include:
switchport mode access
switchport mode stack
switchport mode trunk
Syntax Description
access
stack
trunk
Default Values
By default, switchport mode is set to access.
Command History
Release 5.1
Functional Notes
Configuring the interface for stack mode (using the switchport mode stack command) enables the switch
to communicate with other switches that it is stacking capable.
f the switch is configured as the stack master (using the (config)#stack master command), it will
•
begin advertising itself as a stack master.
f the switch is configured as the stack member (using the (config)#stack member command), it will
•
begin advertising other stack masters that it knows about.
Stack mode also allows the port to transmit and receive packets on all VLANs that are included in the
VLAN allowed list.
Usage Examples
The following example sets the port to be a trunk port:
(config)#interface ethernet 0/1
(config-eth 0/1)#switchport mode trunk
60000CRG0-35E
Sets port to be a single (nontrunked) port that transmits and receives no
tagged packets.
Sets the port to allow it to communicate with a switch stack. (Does not apply
to the NetVanta 300 Series units.)
Sets port to transmit and receive packets on all VLANs included within its
VLAN allowed list.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1719