Fxs Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
FXS I
NTERFACE
To activate the Foreign Exchange Station (FXS) Interface Configuration mode, enter the interface fxs
command and specify the FXS port at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface fxs 2/1
(config-fxs 2/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
battery-mode on page 1760
caller-id on page 1761
holdover <value> on page 1762
impedance on page 1763
loopback on page 1765
onhook-transmission on page 1766
ring-frequency <value> on page 1767
ring-voltage <value> on page 1768
rx-gain <value> on page 1769
signal on page 1770
test commands begin on page 1771
tx-gain <value> on page 1777
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

FXS Interface Command Set

1759