Table of Contents
Advertisement
Command Reference Guide
spanning-tree edgeport
Use the spanning-tree edgeport command to enable or disable the interface as an edgeport. This
command overrides the related global setting (refer to
Variations of this command include:
spanning-tree edgeport disable
spanning-tree edgeport enable
Syntax Description
disable
enable
Default Values
By default, this setting is disabled.
Command History
Release 5.1
Release 8.1
Release R10.1.0
Functional Notes
When an interface is designated as an edgeport, the interface will immediately go into a forwarding state
when the link becomes active. When an interface is not designated as an edgeport, the interface must
progress through the listening and learning states before going to the forwarding state.
Usage Examples
The following example specifies that the interface is an edgeport:
(config)#interface ethernet 0/1
(config-eth 0/1)#spanning-tree edgeport enable
The following example disables the interface as an edgeport:
(config)#interface ethernet 0/1
(config-eth 0/1)#spanning-tree edgeport disable
60000CRG0-35E
Specifies that the interface is not an edgeport.
Specifies that the interface is an edgeport.
Command was introduced.
Command was added to the ATM subinterface command set.
Command was expanded to include the disable and enable keywords.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
spanning-tree edgeport default on page
1345).
1707
Advertisement
Table of Contents
